Electrical Ground Strap: Function, Selection and Specification
An electrical ground strap is a conductive link used to connect equipment metalwork to a designated grounding or bonding point. Before choosing a copper braid, strip or other construction, establish the connection’s electrical function and the protection requirements of the equipment.

How an Electrical Ground Strap Supports Fault Protection
Bonding electrically joins conductive parts. When a strap provides protective bonding, it forms part of the path that carries fault current if a live conductor contacts exposed metalwork. The strap, its joints and the rest of the protective circuit must be considered together with the protective device.
In a TN system, the protective-conductor connection provides a return path to the supply source so that appropriately selected protection can disconnect a fault. A TT system uses an installation earth electrode and normally relies on residual-current protection. Other arrangements, including IT systems, require their own protection strategy. Schneider Electric’s earthing-system guide explains these distinctions.
A strap does not itself interrupt a fault, and describing it as a path to earth does not establish that a fuse or circuit-breaker will operate as required. The equipment designer must specify its protective duty and the applicable acceptance requirements. A grounding strap is not a general-purpose neutral-to-frame connection.
EMC and Lightning Are Different Duties
EMC bonding: a connection intended to control electromagnetic interference must be assessed for the relevant frequency range and bonding layout. Strap length, geometry and connections matter. A low DC resistance reading alone does not demonstrate noise-control performance or prove that every flat strap is better than a cable.
Lightning protection: bonding is one part of a coordinated protection system with its own conductor, connection and surge-protection requirements. An ordinary equipment ground strap is not a standalone lightning-protection device, and its protective-bonding use does not establish suitability for lightning current.
If one connection serves more than one function, identify every required duty. Functional bonding does not replace a required protective connection merely because both are described as grounding.
Choose the Construction for the Approved Duty
Braided straps use multiple fine copper strands woven together into a flexible conductor.
Braid is useful where the approved connection needs flexibility. A formed solid copper strip may suit a stable connection, while a laminated assembly uses a different construction that must be defined explicitly. These forms are not interchangeable solely because their outside dimensions match. A properly specified cable may also be appropriate.
Confirm the conductive copper cross-section, prepared end construction and intended installation. Do not infer copper area from the outside width and thickness of a braid, or transfer another product’s catalogue current value to a custom strap. Mechanical flexibility is not evidence of fault-current capability or unlimited bending life.
For bare or tinned copper, identify the finish on the conductor and its terminals and the materials they contact. Include the operating environment. If a covering is required, specify its material, coverage and operating requirements. Neither tin plating nor an unspecified sleeve establishes an outdoor, corrosion or insulation rating.
Specify the Complete Connection Before Ordering
First check whether an approved standard part already meets the equipment requirement. If a custom electrical ground strap is needed, keep the electrical requirement and manufacturing drawing together. A drawing-controlled component is not automatically equivalent to a listed or approved product required by the project.
- Function and duty: identify protective bonding, EMC or another specified role, the approved conductor requirement and any required fault or transient duty. State the applicable equipment specification rather than asking the supplier to infer a rating from strap size.
- Interfaces and route: provide the two connection points, terminal and hole details, installed length and required movement. Define the contact-surface requirements and supplied fixing hardware.
- Material and environment: state the copper specification, finish, mating materials, any covering and relevant exposure conditions.
- Acceptance and records: identify the drawing revision, inspection requirements and any required electrical or movement evidence. Agree the verification responsibility and scope before ordering.
A dimensional check confirms fit, not the performance of the complete protective circuit. Likewise, a continuity result is not a substitute for required fault-duty or EMC evidence. Keep these acceptance decisions separate so a mechanically correct sample is not mistaken for a fully qualified connection.
Carsai supplies custom copper grounding and bonding parts to customer drawings. Share the ground-strap drawing and its approved electrical requirements with the material, finish, quantity and required records so the supplied component and any additional verification can be scoped clearly.


